On March 19th I went and saw the doctor from Mercy Medical in Baltimore that has been trying to keep by biliary drains free from the constrictions of the tumor below my liver. Practice on some pine or poplar first to get a feel for the tool and ensure you can produce square rabbets.įor more information like this on handplanes, check out the handplanes section of my blog here and consider my book “ Handplane Essentials,” available from figured I'd give everyone a health update. Oh, and if you are cutting your first rabbets by hand, don’t do it on the sides of your curly maple carcase. Tilt the square slightly so only one edge of the blade bears on the rabbet. Too often, beginners find out their rabbets are sloped at assembly, when the glue is wet and the clamps are going on.Ĭheck your rabbets with a combination square. Too often, beginners instead put their heads over the escapement to watch the pretty shavings fly out.īutting your head over the work (toward the center of your workbench) will definitely help you plane 90°.Ĥ. You can even move your head forward of the tool a bit to see if the fence is bearing flat against the work. With fenced planes, put your head over the work and beyond the sidewall of the tool. In handwork, the position of your head is important. That will train you to push forward with your dominant hand and not twist the tool.ģ. Push only with the butt of your palm, no fingers. Until you figure out how to hold the tote with a loose grip, don’t grip the tote. This creates a rabbet that slopes away from the shoulder. Most beginners hold the rear tote way too tight. Many fences have holes for just this purpose.Ģ. If you really struggle with the grip, consider adding a thin piece of wood to the fence that increases the bearing surface of the fence. If you are cutting deep rabbets, I recommend lining up the edge of your work with the front edge of the benchtop to have more bearing surface at the bottom of the cut. Grabbing the knob will only cause you to tilt the tool. The proper grip for a fenced plane is to put your fingers on the fence and your thumb directly in front of (but not on) the escapement, where the shavings come out. At the very least, don’t grasp it during planing. If the plane has a front knob, I recommend you remove it.
When I teach people how to use a moving fillister plane, here are some tips I offer them to assist their efforts.ġ. Cutting a square rabbet with a rabbeting plane is a challenge for beginners usually they cut a rabbet that slopes in toward the shoulder or away from the shoulder.
0 kommentar(er)
